Settings; Service Setup - NetComm 3G10WVR User Manual

3G Settings
4.1 3G Service Setup
6HOHFW \RXU * VHUYLFH VHWWLQJV DFFRUGLQJ WR SUHGHÛQHG RU FXVWRP SURÛOHV 6HWXS LQVWUXFWLRQV DUH SURYLGHG LQ WKH IROORZLQJ VHFWLRQV IRU
your assistance.
4.1.1 3G Settings
7KLV PHQX LQFOXGHV * VHUYLFH 6HWXS DQG 3,1 &RQÛJXUDWLRQ
NOTE: Sections 8.3 and 8.4.2 also provide information about the 3G service.
  Ø /QNÚKDØ2DSTO
<RXU 6HUYLFH 3URYLGHU ZLOO SURYLGH WKH LQIRUPDWLRQ UHTXLUHG WR FRPSOHWH WKH ÛUVW WLPH VHWXS LQVWUXFWLRQV EHORZ 7KLV LQFOXGHV SURÛOH
username and password. Only complete those steps for which you have information and skip the others.
1. If your SIM card is not inserted into the Router, then do so now.
2. 7\SH WKH $31 LQ WKH $31 ÛHOG $XWKHQWLFDWLRQ 0HWKRG VKRXOG EH SURYLGHG E\ \RXU ,QWHUQHW VHUYLFH SURYLGHU RU MXVW OHDYH LW WR
$872 LI QRW DFTXLUHG ,I \RX KDYH QRW UHFHLYHG WKH XVHUQDPH DQG SDVVZRUG OHDYH WKHVH ÛHOGV HPSW\
3. Select IP compression and Data compression to be ON or Off. By default they are set to off.
4. Click the Save button to save the new settings.
5. Press the Connect button to reboot the router and to connect to Internet. After reboot, the Device Info for
3G network box in the WUI Basic screen should indicate an active connection, as shown below. The 3G and
Internet LEDs on the front panel of the Router should also be blinking.
,I WKH /('V DUH RII WKHQ HLWKHU \RXU SURÛOH VHWWLQJV DUH LQFRUUHFW WKH 6,0 FDUG LV QRW ZRUNLQJ RU WKH VHUYLFH QHWZRUN LV XQDYDLODEOH ,Q
either case, contact Technical Support for further instructions.
NOTE: If the LEDs light in an on/off pattern moving from left to right this indicates that your SIM is PIN Locked, please lee PIN Lock Off on page 21 for instruction on how
WR Û[ WKLV
HSPA WiFi Router with Voice User Guide
16
YML10WVR
www.netcommlimited.com