Table of Contents
Advertisement
8.2
Operating instructions :
8.2.1
Setting the torque :
Your cordless drill is fitted with a 20-level torque setting (3) with a slip
coupling. This enables you to select the perfect setting for the job in hand.
Start work with a low torque setting.
When you insert the first screw you will find out how much torque is required.
If the torque provided by the current setting is inadequate, set it to the next
level.
If the screw can be inserted as intended down to the surface of the work piece,
the drill/screwdriver is set to the correct torque.
8.2.2
Keyless chuck :
To insert drill bits : set the drill to turn clockwise, insert the bit and hold the
front ring on the chuck. Start the drill at a slow speed.
To remove drill bits : set the drill to turn anti-clockwise and hold front ring on
the chuck. Start the drill at a low speed.
8.2.3
Variable speed
By pressing the ON/OFF switch (1) you can control the speed of the drill from
0 to maximum speed.
8.2.4
Drilling
Set speed setting to
When drilling hard smooth surface, use a center punch to mark the desired
hole location.. This will prevent the drill bit from slipping off center as you
start drilling.
Hold the tool firmly and place the tip of the drill or bit into the work piece,
apply enough pressure to drill
Do not force or apply side pressure to elongate a hole.
8.2.5
Screwing :
Torque setting to 1-20.
Set the direction of rotating slider to clockwise.
For removing screws set it to anti-clockwise.
Use the appropriate flathead or crosshead bit.
Copyright © 2015
FS-50-NICD-2B
.
P a g e
| 8
EN
www.Ford-tools.com
Advertisement
Table of Contents
