8 GETTING STARTED
Before any intervention on product, ensure that product is
disconnected form its power source
8.1
Inserting and removing a socket(Fig B)
- To install a socket on the anvil, Align the
hole of the socket with the anvil and push
down firmly. Ensure it is centered and
properly fixed.
- To remove a socket from the anvil : Pull
socket out firmly
8.2
Switch (Fig. C)
To operate tool, press switch(2) (Fig. A ).
To stop tool, release switch.
The switch has 2 positions :
- on top: (R) to reverse (go counter-
clockwise)
- on bottom: (F) to go forward (clockwise)
9 OPERATING INSTRUCTIONS
Connect product to a power source (refer to characteristics on product).
§
Wear appropriate protective equipment.
§
Prepare material for work
§
Secure material if necessary.Do not use your own weight or body to hold
§
material.
Firmly hold tool with both hands. Always maintain a balanced and secure
§
position.
Place socket on material. Do not make sudden movements.
§
Press on rocker switch [(R) or (F)] to start operation.To stop tool, release
§
rocker switch.
Note: do not put down product until chuck has completely stopped rotating.
Warning:Please stop the tool before changing the direction of rotation.
Fig B
Fig C
P a g e
| 8