Table of Contents
Advertisement
g.
Use the power tool, accessories and tool bits etc. in accordance with
these instructions, taking into account the working conditions and
the work to be performed. Use of the power tool for operations different
from intended could result in a hazardous situation.
5.5
Service
a)
Have your power tool serviced by qualified repair person using only
identical replacement parts. This will ensure that the safety of the power
tool is maintained.
6 SPECIFIC SAFETY WARNINGS FOR CORDLESS
DRILL/DRIVERS
Important! Use of any accessories or attachments other than those supplied or
recommended in these operating instructions can mean the risk of injury.
When using the cordless drill/driver ear protectors and a face mask should be
worn, particularly when hammer drilling in concrete. Exposure to noise can
cause damage to hearing.
Always use the guide handle supplied. Lack of control over the power tool can
lead to injuries.
Do not use the drill/driver on asbestos or materials containing asbestos.
Do not leave power tools running unattended. Always switch off and do not put
down or leave until it has stopped completely.
Long hair must be covered. Do not work in loose fitting clothing.
Be careful when working on walls. Damage to power supply lines, gas or water
pipes can lead to dangerous situations. Use appropriate detectors to establish
whether there are concealed wires or pipes in the working area.
Secure the work piece. The work piece is only secure if it is held by work-
holding devices or in a vice.
7 SAFETY INSTRUCTIONS FOR CHARGER UNIT AND
BATTERIES:
The battery pack should be removed before maintenance or lengthy periods of
non-use.
The battery should be charged every six months during lengthy periods of
non-use.
Only use the recommended battery pack
Please read the regulations and safety instructions before charging the
battery.
Only use the specified charger unit for charging the battery. Do not charge any
other batteries with this charger unit. The mains adapter should only be used
together with this charger unit and the appropriate battery pack.
The charger unit should only be used in a dry environment at temperatures
between 10°C and 40°C.
Do not use the charger unit if it is damaged.
Only have the charger unit and the battery repaired by an authorised after-
sales service department.
Avoid short-circuiting the battery. Ensure that the battery terminals do not
come into contact with metal objects.
Do not keep the battery in places where the temperature can reach 50°C and
more, for example in a car parked in the sun.
Copyright © 2015
FS-50-NICD-2B
P a g e
| 6
EN
www.Ford-tools.com
Advertisement
Table of Contents
