Advertisement
Thank you for purchasing the Azden 310 Diversity Wireless Microphone system. The components
included with your system will vary depending on the system configuration you purchased. Below are
the possible system configurations available with the 310UDR Diversity Receiver.
310LT
1 x 310UDR Diversity Receiver
1 x Stereo Mini-Plug to XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-Pack Transmitter
1 x EX-503L Lavalier Microphone
310HT
1 x 310UDR Diversity Receiver
1 x Stereo Mini-Plug to XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35HT Handheld Microphone / Transmitter
310XT
1 x 310UDR Diversity Receiver
1 x Stereo Mini-Plug to XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35XT XLR Plug-in Transmitter
CAUTION
• Do not use batteries other than the ones specified in this manual. Do not mix fresh battery with used battery.
• When installing batteries, make sure the battery polarity is correct as marked inside the battery compartment.
• Remove the batteries before long-term storage of the transmitters or receiver.
• Do not submerge any of the components in water.
Quick Start Guide
1. Install new AA alkaline batteries into the receiver and transmitters.
2. For 35BT: Connect the EX-503L lavalier microphone to the MIC input on the 35BT.
For 35XT: Connect your XLR microphone (not included). Turn on phantom power if required.
For 35HT: Nothing needs to be connected as it is a Microphone / Transmitter in one.
3. Turn on your transmitter. You should see information displayed on the LCD. Be sure to also turn the
AUDIO switch to ON.
4. Set the transmission frequency for the transmitter by pressing the Channel UP/DOWN buttons.
5. Turn on the receiver. Using the Channel UP/DOWN buttons, set the frequency displayed in the
LCD to match that of the transmitter set previously.
6. The receiver should now be connected to the transmitters. To check, you can connect headphones
to the PHONE jack of the receiver and listen for audio.
Please Note
If your system came with more than one transmitter, they cannot be used simultaneosly with the
same 310UDR receiver. The purpose is to give you the option of using one or the other.
When using multiple 310 systems in the same area, set the frequencies for each system to be at least
16 channels apart. (ie: 30-01 and 30-17).
For a more detailed description of component controls, functions and setup, please continue
reading this manual.
310LH
1 x 310UDR Diversity Receiver
1 x Stereo Mini-Plug to XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-Pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35HT Handheld Microphone / Transmitter
310LX
1 x 310UDR Diversity Receiver
1 x Stereo Mini-Plug to XLR Cable
1 x Stereo Mini-Plug to Mini-Plug Cable
1 x 35BT Body-Pack Transmitter
1 x EX-503L Lavalier Microphone
1 x 35XT XLR Plug-in Transmitter
3
Advertisement
