S&P Quadro-250 Instruction For Use & Installation Instructions page 11

Do not leave packaging within the reach of children and recycle it in
agreement with the by-laws in force.
Before connecting the appliance to the electrical supply, ensure that the
supply voltage coincides with that indicated on the appliance´s characteristic
plate.
For connection to the electrical supply use a
power cable.
Do not position the supply cable with a curvature radius of less than 50
mm. The heating appliance must not be placed directly below a power socket
and must not be installed inside the bathroom. Place the appliance at a minimum
height of 1.80m, leaving at least, 50 cm between the heater and the ceiling
This product must not be used by persons (including children) with
physical, sensorial or mental disabilities or without sufficient knowledge or
experience, if they are not under the supervision of a responsible,suitably
instructed person. Children must be supervised to ensure they do not play with
the product.
Do not touch to the appliance with wet hands or the wet feet and
do not stretch the power cable.
The connection of the appliance to the mains must be provided
with a bipolar switch with a minimum contact opening of 3mm and must
be in compliance with the standards in force in the country where it is to be
installed.
The radiant frontal surface of the panel must remain free and
uncovered by objects as these may damage it beyond repair and provoke a fire.
It is therefore indispensable that these safety warnings are followed during the
installation of the product:
- Leave a distance of at least 50 cm between the surface of the
panel and the objects that are below it.
H05VV-F 2 x 0.75 mm
11
2
.