Advertisement
Mounting the Antenna on a Ceiling Tile
Figure 1
1
2
Follow these steps to mount the antenna on a suspended ceiling tile.
Mark the location on the ceiling tile where you will mount the antenna.
Step 1
Remove the ceiling tile from the ceiling grids.
Step 2
Use a hole cutter to create a a 1-in. (2.54-cm) hole in the ceiling tile.
Step 3
Insert the antenna cables, one at a time, through the hole in the ceiling tile.
Step 4
Line up the plastic nut and washer as shown in
Step 5
Insert the antenna cables, one at a time, through the hole in the plastic nut.
Step 6
Note
Make sure that the antenna is properly positioned on the ceiling tile and then tighten the plastic nut
Step 7
hand-tight as shown in
78-19022-02
Ceiling Tile Mounting Details
Plastic nut
Antenna cables
Do not use the rubber washer when you mount the antenna on a ceiling tile. The washer is not
required for ceiling tile installations.
Figure
2.
Cisco Aironet Dual Band MIMO Low Profile Ceiling Mount Antenna (AIR-ANT2451NV-R)
1
2
3
4
3
Ceiling tile
4
Antenna
Figure
1.
Installation Notes
7
Advertisement
