SAFETY WARNINGS AND GUIDELINES Please read this entire manual before using this device, paying extra attention to these safety warnings and guidelines. Please keep this manual in a safe place for future reference. This device is intended for indoor use only. ...
Ensure that power is turned off and disconnected before making any electrical connections. Remove the batteries from the controller if it will go unused for a lengthy period of time. Clean using a soft, dry cloth only. Do not use chemical cleaners, solvents, or detergents.
If you have any problem with your order, please give us an opportunity to make it right. You can contact a Monoprice Customer Service representative through the Live Chat link on our website www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-...
PACKAGE CONTENTS Please take an inventory of the package contents to ensure you have all the items listed below. If anything is missing or damaged, please contact Monoprice Customer Service for a replacement. 1x 4K 2x7 HDBaseT™ Splitter 12x Receiver Mounting Ears...
4. HDMI 2: Switch for selecting the HDMI® 2 input. The corresponding LED illuminates when the input is selected. 5. INPUTS: Two HDMI inputs for connecting two HDMI source devices. 6A: HDBT OUTPUTS: Six RJ45 connectors for attaching a Cat6 Ethernet cable to connect the HDBaseT™...
Wallplate HDMI 1 HDMI 2 1. SOURCE SELECTOR: Press the button to swap between the HDMI® 1 and the HDMI 2 inputs. The corresponding LED will illuminate to indicate the selected source. 2. POWER BUTTON: Press the button to turn the splitter and all connected receivers on or off.
INSTALLATION Perform the following steps to install the splitter kit. 1. Ensure that all equipment to be connected is powered off and unplugged from its power source. 2. Place or install the splitter in its intended location. Use the included mounting ears and/or plastic feet, as desired.
Page 10
10. (Optional) Build a stereo analog cable using a 5-pin push terminal (not included) and balanced or unbalanced connectors of the appropriate type. Once the cable is built and tested, plug one end into your external audio device (mixer or amplifier) and the other end into the AUDIO OUTPUT connector on the splitter.
EDID MANAGEMENT The splitter scan the active outputs and will send the EDID capabilities of the first detected display to the two inputs. If all your displays have the same number of audio channels and the same maximum resolution, all is well. However, if you have displays with differing capabilities, you should connect the display with the lowest maximum resolution and the least number of audio channels to the 1-HDBT output.
Page 12
Receivers Maximum Resolution 4K@60Hz Bandwidth 10.2 Gbps HDMI® Version HDCP Version Transmission Mode HDBaseT™ 1080p@60Hz: up to 229 feet (70 meters) Maximum Transmission Distance 4K@60Hz: up to 131 feet (40 meters) Input Power Power over Cable (PoC) Operating Temperature +32 ~ +122°F (0 ~ +50°C) Operating Humidity 10 ~ 90% RH, non-condensing Dimensions (each)
REGULATORY COMPLIANCE Notice for FCC Modifying the equipment without Monoprice's authorization may result in the equipment no longer complying with FCC requirements for Class B digital devices. In that event, your right to use the equipment may be limited by FCC regulations, and you may be required to correct any interference to radio or television communications at your own expense.
Need help?
Do you have a question about the Blackbird 4K 2x7 HDBaseT and is the answer not in the manual?
Questions and answers