Wall Mounting - ABB UNO-DM-TL-PLUS-US Product Manual

W
all mounting
During installation do not place the inverter with the front covers
Install the inverter by following this procedure:
Position the bracket
1.
01
vertical support (pole, wall, frame,
etc) and use it as drilling template.
It is the installer's responsibility
to choose an appropriate number
and and distribution of attachment
points. The choice must be based
on the type of wall, frame or other
support, the type of anchors to
be used, and their ability to sup-
port 4 times the inverter's weight
(4 x 33lbs=132 lbs for all models).
Attach the bracket to the wall with
at least 4 attachment srews. De-
pending on the type of anchor
chosen, drill the required 4 holes
(minimum) to mount the bra-
A
cket.
2. Attach the bracket to the wall or
frame
Risk of injury due
to the weight of the
equipment.
3. Lift the inverter and hang it to the
bracket by inserting the two sup-
01
ports in the slots on the inverter (Fig-
ure ).
B
4. Proceed to anchor the inverter to the
bracket by pressing the lower part to-
ward the wall or frame until the two
springs on the bracket
02
inverter in position (Figure
5. Secure the lower bracket of the in-
verter to the wall or frame using
an appropriate type of
on the
A
set the
01
).
B
anchor.
facing the ground.
04 05
- 50 -
5 - Installation
B
C