Tools Section - ABB UNO-DM-TL-PLUS-US Product Manual

T
OOLS section
In the TOOLS section it's possible to access the following sub-menus:
• Dynamic Feed-in Control
• Local I/O Manager
• Country Standard
• Autotest CEI 0-21
• Firmware Update
• Date/Time
Dynamic Feed-in Control
In the Dynamic Feed-in Control sub-menu it's possible to enable the
management of power flows in order to optimize self-consumption or
avoid feeding power to the grid (except during transitory), basing on the
reading of the energy meter:
No UL meters are available at the moment. The selection of the meter must be "None"
- Meter:
When a meter device is connected to the inverter, it's
requested to select the meter model:
1. None (where system is installed without meter)
2. REACT-MTR-1PH (single-phase). Not UL certifified.
3. ABB B23 1PH (single-phase). Not UL certifified.
4. ABB B23 3PH (three-phase). Not UL certifified.
- 102 -
7 - Operation