Troubleshooting - Hilti PM 40-MG Operating Instructions Manual

6.2 Hilti Calibration Service
We recommend that the tool is checked by the Hilti Calibration Service at regular intervals in order to verify
its reliability in accordance with standards and legal requirements.
Use can be made of the Hilti Calibration Service at any time. Calibration at least once a year is recommended.
The Hilti Calibration Service provides confirmation that the device is in conformance, on the day it is tested,
with the specifications given in the operating instructions.
The tool will be readjusted if deviations from the manufacturer's specification are found.
After checking and adjustment, a calibration sticker applied to the tool and a calibration certificate provide
written verification that the tool operates in accordance with the manufacturer's specification.
Calibration certificates are always required by companies certified according to ISO 900X.
Your local Hilti contact will be pleased to provide further information.
7 Transport and storage
7.1 Transport
▶ Use the Hilti shipping box or packaging of equivalent quality for transporting or shipping your equipment.
7.2 Storage
▶ Remove the tool from its case if it has become wet.
▶ The tool, its carrying case and accessories should be cleaned and dried (at maximum 63 °C/145 °F).
▶ Repack the equipment only once it has dried completely and then store it in a dry place.
▶ Check the accuracy of the equipment before it is used after a long period of storage or transportation.
7.3 Transport and storage of cordless tools
Transport
CAUTION
Inadvertent starting during transport. Uncontrolled starting during transport may occur if the battery
is fitted, thereby resulting in damage to the tool.
▶ Always remove the battery before transporting the tool.
▶ Remove the battery.
▶ Transport the tool and batteries individually packaged.
▶ Never transport batteries in bulk form (loose, unprotected).
▶ Check the tool and batteries for damage before use after long periods of transport.
Storage
CAUTION
Inadvertent damage caused by defective battery. A leaking battery may damage the tool.
▶ Always remove the battery before storing the tool.
▶ Store the tool and batteries in a place that is as cool and dry as possible.
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.

8 Troubleshooting

If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The tool can't be switched
on.
14 English
Printed: 07.09.2017 | Doc-Nr: PUB / 5343709 / 000 / 02
Possible cause
The battery is low.
The battery is not fitted correctly.
Action to be taken
▶ Charge the battery.
▶ Fit the battery and check that
the battery is securely seated in
the tool.