Rear Panel - Planex BLW-54MR User Manual

Rear Panel

Power port Connect the supplied power adapter here.
10/100BaseT Use standard LAN cables (RJ45 connectors) to connect your PCs to
LAN connections these ports.
If required, any port can be connected to another hub. Any LAN port
will automatically function as an "Uplink" port when necessary.
WAN port Connect the DSL or Cable Modem here. If your modem came with a
(10/100BaseT) cable, use the supplied cable. Otherwise, use a standard LAN cable.
This button has two (2) functions:
Reset Button
"
"
To Clear All Data and restore the factory default values:
1.
2.
3.
4.
Antenna If the antenna is detachable, connect it here. When in use, best results
are usually obtained with the antenna in an upright position.
Figure 3: Rear Panel
Reboot. When pressed and released, the Wireless Router will
reboot (restart).
Clear All Data. This button can also be used to clear ALL data
and restore ALL settings to the factory default values.
Power Off.
Hold the Reset Button down while you Power On.
Keep holding the Reset Button for a few seconds, until the RED
LED has flashed TWICE.
Release the Reset Button. The Wireless Router is now using the
factory default values.
Introduction
5