Related Publications; System Configurations; System - Honeywell CAS-100 Maintenance Manual

Table 4. CAS-100 and Aircraft Optional Equipment (cont)
Optional
Aircraft Equipment
Performance Management
Computer
Wind Shear System and/or
Ground Proximity System
ARINC 615 Data Loader (airborne or
portable)
NOTE: PPI display shows independently or total radar and TCAS traffic on the same display.
F. Related Publications
Table Intro-1. lists related publications including the subsystems and units comprising the
CAS-100 Collision Avoidance System and test equipment supporting the system.

2. System Configurations

A. System
The total CAS-100 system configuration is dependent on the equipment available in the
applicable aircraft.
The following text gives the available configurations and features for the TCAS processor.
NOTE: Available configurations and features for the Mode S transponder and the control units,
are shown in isolated manuals (refer to Related Publications, Table Intro-1.).
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
MAINTENANCE MANUAL
CAS-100 COLLISION AVOIDANCE SYSTEM
Supplies the aircraft climb rate performance limit discrete
input to the TPA-100A TCAS Processor.
Supplies the TCAS advisory inhibit discrete input to the
TPA-100A TCAS Processor during wind shear or ground
proximity alarm conditions.
Reprograms the TCAS processor program memory
without requiring physical access to the unit.
Programming is done through ARINC 429 input and output
ports on the TCAS processor rear connector or a
dedicated data loader connector on the front panel. The
data loading can be done at the low-speed or high-speed
ARINC 429 data transfer rate. A data loader adapter cable
(Honeywell Part No. 300-80179-0501) is supplied to
connect a portable data loader to the TCAS processor
front panel connector.
Description
34-45-47
Page 18
1 Dec 2003