Honeywell CAS-100 Maintenance Manual page 144

CAS-100 COLLISION AVOIDANCE SYSTEM
2 After the RA/VSI sequence lamp test, the red and green climb/descend lamps
show a set test command that shows a typical resolution advisory during the
remaining test sequence.
NOTE: The missing correct vertical speed input causes the VSI flag to come into
the view on the RA/VSI. If a TA/VSI is used, the legend VSI comes into
the view on the display. A TCAS processor failure causes the TCAS flag
to come into the view on the RA/VSI, and the TCAS to come into the view
on the TA/VSI.
(c) For the aircraft that have TA/VSI
The TA/VSI shows a set Resolution Advisory and the traffic symbol test pattern. A
TEST message is shown.
(d) For the aircraft that have PPI Radar/TCAS or dedicated display:
The PPI or dedicated display shows the TCAS display test pattern and TEST is
shown.
(e) At the correct end of the self-test, the TCAS processor output on the audio bus
starts the synthesized voice message, TCAS System Test OK.
Use or disclosure of information on this page is subject to the restrictions in the proprietary notice of this document.
MAINTENANCE MANUAL
Test Pattern
Figure 1001
34-45-47
Page 1003
1 Dec 2003