Switching On The Drystar Axys - AGFA Drystar AXYS User Manual

D AXYS
RYSTAR

Switching on the Drystar AXYS

Follow the procedure below to ensure proper start-up of the Drystar AXYS and
to check that everything is working correctly.
Procedure:
1 Check that the power cord is plugged in and then switch on the printer by press-
ing the Power/Reset button.
On the display, the following message is displayed. After a short while, a progress indi-
cator will show the progress of the self-test.
If anything goes wrong during the self-test, refer to
2 The printer is ready for operation:
48
Note: Before switching on the Drystar AXYS, read the safety instructions.
Refer to "Safety Directions" on page 43.
"Start-up errors" on page 256.
2852 A EN 20070205