Changing The Film Format Of The Trays - AGFA Drystar AXYS User Manual

D AXYS
RYSTAR
Procedure:
1 Switch off the Drystar AXYS (refer to
page 63).
2 Disconnect the cables.
3 Move the Drystar AXYS to its destination (with 2, preferably 3 persons!).
4 Reconnect the cables.
5 Switch Drystar AXYS on (refer to

Changing the film format of the trays

The key-operator can adjust the film size setting of both input trays (8x10" up to
14x17" film sizes).
Before a different film format can be loaded, the film format settings of the tray
has to be changed. After this modification, the 'film format' parameter is auto-
matically read from the Film Identification tag when the new film pack is
loaded.
32
"Switching on the Drystar AXYS"
Note: Never load another film format when the input tray is not empty.
Intermediate changing of film formats increases the risk for dust, which
can damage the thermal print head (TPH).
Note: The system performs an automatic calibration when the film format
has been changed.
"Switching off the Drystar AXYS" on
on page 48).
2852 A EN 20070205