Use The 4G Lte Router As A Dhcp Server - TP-Link Archer MR400 User Manual

Chapter 11
5. You can configure the router's
through which you can also access the web management page.
6. Leave the rest of the default settings as they are.
7. Click Save to make the settings effective.

11. 4. 2. Use the 4G LTE Router as a DHCP Server

You can configure the router to act as a DHCP server to assign IP addresses to its clients.
To use the DHCP server function of the router, you must configure all computers on the
LAN to obtain an IP Address automatically.
Follow the steps below to configure DHCP server.
1. Visit http://tplinkmodem.net, and log in with the password you set for the router.
2. Go to Advanced
3. Select DHCP to enable the DHCP function and select
4. Specify the IP Address
same subnet with LAN IP. The router will assign addresses within this specified
range to its clients. It is from 192.168.1.100 to 192.168.1.200 by default.
5. Enter a value for the
of time in which a DHCP client can lease its current dynamic IP address assigned
by the router. After the dynamic IP address expires, the user will be automatically
assigned a new dynamic IP address. The default is 1440 minutes.
6. Keep the rest of the settings as default and click
Note:
1. The router can be configured to work as a
between computers that request IP addresses and the DHCP server that assigns the addresses. Each of the device's
interfaces can be configured as a DHCP relay. If it is enabled, the DHCP requests from local PCs will be forwarded to
the DHCP server that runs on WAN side.
Second IP
> Network > LAN Settings
Pool, the start address and end address must be on the
Address Lease Time. The
DHCP Relay. A DHCP relay is a computer that forwards DHCP data
Specify Your Network Settings
and Subnet Mask
page.
DHCP Server.
Address Lease Time
Save to make the settings effective.
for LAN interface
is the amount
48