Power-On Password; Hard Disk Password; Supervisor Password; How To Remove The Power-On Password - Lenovo ThinkPad X1 Carbon 20HQ Hardware Maintenance Manual

Power-on password

A power-on password protects the system from being powered on by an unauthorized person. The
password must be entered before an operating system can be started. For instructions on how to remove
the power-on password, see "How to remove the power-on password" on page 34.

Hard disk password

There are two kinds of hard disk passwords:
• User hard disk password - for the user
• Master hard disk password - for the system administrator, who can use it to get access to the hard disk
even if the user has changed the user hard disk password
Note: There are two modes for the hard disk password: User only and Master + User. The Master + User
mode requires two hard disk passwords; the system administrator enters both in the same operation. The
system administrator then provides the user hard disk password to the system user.
Attention: If the user hard disk password has been forgotten, check whether a master hard disk password
has been set. If it has, it can be used for access to the hard disk drive. If no master hard disk password is
available, neither Lenovo nor Lenovo authorized service technicians provide any services to reset either
the user or the master hard disk password, or to recover data from the hard disk drive. The hard disk drive
can be replaced for a scheduled fee.
For how to remove the hard disk password, see "How to remove the hard disk password" on page 35.

Supervisor password

A supervisor password protects the system information stored in the ThinkPad Setup. The user must enter
the supervisor password in order to get access to the ThinkPad Setup and change the system configuration.
Attention: If the supervisor password has been forgotten and cannot be made available to the service
technician, there is no service procedure to reset the password. The system board must be replaced for
a scheduled fee.

How to remove the power-on password

To remove a power-on password, do the following:
If no supervisor password has been set, do the following to remove the power-on password:
1. Turn off the computer and disconnect ac power.
2. Disable the built-in battery. See "Disabling the built-in battery" on page 68.
3. Remove the base cover assembly. See "1010 Base cover assembly" on page 69.
4. Remove the internal battery pack. See "1090 Built-in battery" on page 77.
5. Remove the coin-cell battery. See "1050 Coin-cell battery" on page 73.
6. Reinstall the coin-cell battery.
7. Reinstall the internal battery pack.
8. Reinstall the base cover assembly.
9. Reconnect ac power.
10. Turn on the computer and wait until the POST ends. After the POST ends, the password prompt does
not appear. The power-on password has been removed.
If a supervisor password has been set and is known to the service technician, do the following to remove
the power-on password:
34
Hardware Maintenance Manual