Power Supply Modules - Cisco Firepower 4100 Series Hardware Installation Manual

Overview
Table 5: DC Power Supply Module Hardware Specifications
Input voltage
Maximum current
Maximum output power
Redundancy
Efficiency at 50% load
Power Supply Module LEDs
The following figure shows the bicolor power supply LEDs. The LEDs are located on the upper right side.
Figure 12: Power Supply Module LEDs
1
The following table describes the power module supply LEDs.
Table 6: Power Supply Module LEDs
No power to all power supplies
Amber FAIL LED
Amber LED (Fail Status)
Off
Cisco Firepower 4100 Series Hardware Installation Guide

Power Supply Modules

-40 to -60V DC
26A (at 40V DC)
The power supply module is rated at 26A
Note
but the system power is limited to 10A. See
Hardware Specifications, on page 34
more system specifications.
950W
1+1 redundant
92%
2
Green LED (OK Status)
Off
for
Green OK LED
19