Mounting the SkyZhone to a pole
•
cordless screwdriver with a 2 1/2 " extension to be able to secure the
tamper-resistant screws, or a screwdriver that can receive a
tamper-resistant screw that is at least three inches long.
This section describes the steps to mount a pole for the SkyZhone access
point. First select a mounting location. You can attach the SkyZhone access
point to any pipe or pole.
1
Attach tension bands to the pole mounting plate by threading them
through the slots on the mounting plate. The slots are for either horizontal
or vertical mounting on large or small diameter poles. Choose the one
most appropriate for this installation.
Figure 9: Threading tension bands through mounting plate slots
Small diameter
poles use this side
of the mounting
surface
Large diameter poles
use this side of the
mounting surface
2
Secure the tension bands around the pole, following the illustrations
provided with the BAND-IT Tool.
SkyZhone 1624, 1424, 1224 Hardware Installation Guide
Mounting the SkyZhone to a pole
29