Zhone SkyZhone 1624 Hardware Installation Manual page 4

Note:
•
This equipment has been tested and found to comply with the limits for a Class C
digital device, pursuant to part 15, subpart C, of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the user manual, may increase the potential for harmful
interference to radio communications.
WARNING!
The authority to operate this equipment is conditioned by the requirement that
no modifications will be made to the equipment unless the changes or
modifications are expressly approved by the manufacturer.
•
This warning applies to the Skyzhone-1424 only. This equipment has been tested
and found to comply with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which the
user will be required to correct the interference at his own expense..
•
Changes or modifications not expressly approved by Zhone Technologies, Inc.
could void the user's authority to operate the equipment.
•
The supplied cables and antennae must be used to ensure compliance with Part 15,
FCC Rules.
•
This device may only be used with approved antennae that are shipped with the
unit and installed per installation instructions. The use of any other antennas will
invalidate the unit's FCC Part 15 certification.
•
The 2.4 GHz band has been designed to operate with the antennae listed below,
and having a maximum gain of 5 dBi. Antennae not included in this list (Comet
Part Number CFA-245W-SR) or having a gain greater than 5 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms.
•
The 4.9 GHz band has been designed to operate with the antennae listed below,
and having a maximum gain of 5.3 dBi. Antennae not included in this list (Comet
Part Number SF-D49NW-SR) or having a gain greater than 5.3 dBi are strictly
prohibited for use with this device. The required antenna impedance is 50 ohms
•
To reduce potential radio interference to other users, the antenna type and its gain
should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not
more than that permitted for successful communication. Operating the device with
the supplied antennas will ensure that this requirement is met..
•
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.