JVC XL-R5020BK Service Manual page 14

XL-R5020BK
3.1.4 Removing the sub chassis unit
(See Fig.15 to 17)
*Prior to performing the following procedures, remove the servo
control board, the top cover, the tray unit,the side unit (L) and
the side unit (R).
(1) Turn the hook gear counterclockwise to move the slide
hook and the slider (R) backward until they stop.
(2) Slide the slide cam (L) and the slide cam (R) in the direction
of the arrow until they stop.
(The notches of each slide cam are fitted to the pins on
both sides of the sub chassis unit.)
(3) Detach the sub chassis unit upward.
ATTENTION:
When reassembling, turn the hook gear of the chassis
unit counterclockwise until it stops and slide the slide
hook and the slider (R) of the sub chassis unit backward
until they stop.
14
Fig.15
Fig.16
Fig.17