Motorization, Sensor, And Light Drivers; Connecting Z-Wave Devices - Z-Wave Control4 Setup Manual

Motorization, sensor, and light drivers

Connecting Z-Wave devices

Most Z-Wave device drivers will also need a motorization, sensor, or light driver.
For example, a window contact sensor device driver also needs the Window
Contact Sensor driver and an outlet module device driver needs the Z-Wave
Dimmable Light (Outlet) driver.
To add a motorization, sensor or light driver into your project:
1 In System Design, enter the name of the driver in the search field in the
Search tab.
2 Double-click on the driver to add it into the project. You can also right-click
on the driver and select Add to Project to add the driver.
3 This is the driver that will show up in the UI, rename the driver to represent
the device it is controlling. Right-click on the driver and select Rename.
Enter the name to be shown in the UI and press Enter.
After you have added all the necessary device drivers and motorization, sensor
or light drivers into your project, you are ready to make the necessary
connections for these drivers.
There are two types of connections that need to be made:
6