Removing Z-Wave Devices; Removing Z-Wave Devices From The Network - Z-Wave Control4 Setup Manual

Removing Z-Wave devices

Removing Z-Wave devices from the network

Z-Wave devices that are added to the Z-Wave network, but not identified to a
device driver will show up with just the Node ID.
Z-Wave devices can be removed from any network at any time by using the
Remove button found in Available Devices. This is true even if they are not part
of the network performing the remove operation.
Removing Z-Wave devices from a previously installed network requires an
available Z-Wave controller and interaction with the Z-Wave device-usually by
pressing the Z-Wave button on the device. There is no "Remove from mesh"
button press sequence similar to ZigBee Pro devices.
To remove a Z-Wave device from the network:
1 In Connections in the Z-Wave Network, click Remove in the Available
Devices window.
The Removing Z-Wave Device window appears and a 60 second timer
starts.
2 Remove the Z-Wave device from the network according to the
manufacturer's instructions, usually by pressing a Z-Wave button on the
device. See the documentation for the Z-Wave device for more information.
Note: If the device is not removed from the network before the timer ends, close
the window and click the
Remove
button to try again.
10