1. Manuals
  2. Brands
  3. Z-Wave Manuals
  4. Remote Control
  5. RC-100
  6. Quick setup manual

Z-Wave RC-100 Quick Setup Manual

Hide thumbs Also See for RC-100:
Table of Contents

Advertisement

Quick Links

Download this manual
RC-100 Quick Setup Guide
The RC-100 is a portable Z-Wave remote controller with multi- channel
support. It can be configured as a primary or secondary controller
within a Z-Wave home automation network. It works with almost every
Z-Wave enabled devices, binary switches, dimmers, thermostats,
secured door locks, binary or multi-level sensors. Users can control
their Z-Wave enabled devices individually or through
"Scene" control. Scene is a collection of Z-Wave devices configured to
a user-preferred settings, levels, modes or operating conditions. The
RC-100 also equipped with a backlit LCD screen and an intelligent Self
Navigated Button (SNB) system. Users can setup and operate their
Z-Wave devices through the LCD and the SNB system using their
RC-100, and enjoy a networked, wireless home automation system
anywhere at home.

RC-100 USER INTERFACE LAYOUT

Control
or
menu
Home (A1)
• Press
or
• Press BACK key to go back to previous page.
• Press and hold BACK key for 2 seconds to go
back to root menu.
Device (A2)
Scene (A3)
Comfort (A4)
Sensor (A5)
All Off (A6)
1
keys to select control category.
Devices List (A2.1)
Scenes List (A3.1)
Comforts List (A4.1)
Sensors List (A5.1)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RC-100 and is the answer not in the manual?

Questions and answers

Related Manuals for Z-Wave RC-100

Summary of Contents for Z-Wave RC-100

  • Page 1 “Scene” control. Scene is a collection of Z-Wave devices configured to a user-preferred settings, levels, modes or operating conditions. The RC-100 also equipped with a backlit LCD screen and an intelligent Self Navigated Button (SNB) system. Users can setup and operate their...
  • Page 2 • Press and hold keys simultaneously for 3 seconds to enter Setup menu. Setup • Press BACK key to go back to previous page. menu • Press and hold BACK key for 2 seconds to go back to root menu. Setup (B1) Add Device (B2) Delete Device (B3)
  • Page 3 (Rediscover network) Re-scan Devices (C3) Delete Dead Node (C4) Listening Mode (C5) Create Sec. (C6) (Create secondary) Create Pri. (C7) (Create primary) QUICK SETUP STEPS EXAMPLE Step 1 Connect a Z-Wave device (for example, a light switch) to power supply.
  • Page 4 > Add to Scene > OK to Enter Add Device Press key to add Press PROG on target the device into Z-Wave iii) network. >>>> Press the program button Add Device on the target device. Press PROG on target >>>>...
  • Page 5 Z-Wave network. In this case, please delete this device following the steps in the [Deleting Device from the Network] section then add this device again. Step 3 After adding devices to your RC-100, you can turn the device using the corresponding Device Control function. Step Setup Key LCD Indication Select “Device＂and...

  • Page 6: Frequently Asked Questions

    RC-100, please refer to gateway user manual. iii) Now, RC-100 will act as a secondary controller. All scenes and device node information will transfer from gateway to RC-100, you can On/Off the scene through RC-100 [step of A3.1].

Table of Contents