Vertex Standard VZ-30-G6-4 User Manual page 32

SAFETYTRAINING INFORMATION
Your
Vertex Standard LMR, Inc.
energy during transmit mode. This radio is designed for and classified as "Occupational Use
Only", meaning it must be used only during the course of employment by individuals aware
of the hazards, and the ways to minimize such hazards. This radio is NOT intended for use by
the "General Population" in an uncontrolled environment.
This radio has been tested and complies with the FCC RF exposure limits for "Occupational Use Only". In addition,
your
Vertex Standard LMR, Inc.
with regard to RF energy and electromagnetic energy levels and evaluation of such levels for exposure to humans:
FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance with FCC Guidelines for Human Exposure to
Radio Frequency Electromagnetic Fields.
American National Standards Institute (C95.1-1992), IEEE Standard for Safety Levels with Respect to Human Exposure
to Radio Frequency Electromagnetic Fields, 3 kHz to 300 GHz.
American National Standards Institute (C95.3-1992), IEEE Recommended Practice for the Measurement of Potentially
Hazardous Electromagnetic Fields– RF and Microwave.
T
he information listed above provides the user with the information needed to make him or
her aware of RF exposure, and what to do to as‐sure that this radio operates with the FCC RF
exposure limits of this radio.
Electromagnetic Interference/Compatibility
During transmissions, your
possibly cause interference with other devices or systems. To avoid such interference, turn off the radio in areas
where signs are posted to do so. DO NOT operate the transmitter in areas that are sensitive to electromagnetic
radiation such as hospitals, aircraft, and blasting sites.
Occupational/Controlled Use
The radio transmitter is used in situations in which persons are exposed as consequence of their employment
provided those persons are fully aware of the potential for exposure and can exercise control over their exposure.
Attention:
This radio complieswith IEEE and ICNIRP exposure limits for occupational/controlled RF exposure emvironment
at operating duty factors of up to 50% and is authorized by the FCC for occupational use only. An appropriate warning
lable is affixed to all units. In order to comply with RF exposure requirements, a minimum distance of 2.5cm must be
maintained when held-to-face, and body-worn operations are restricted to the approved original acessories (belt clip).
Do not use this device when antenna shows obvious damages
radio generates RF electromagnetic
radio complies with the following Standards and Guidelines
Vertex Standard LMR, Inc.
radio generates RF energy that can