Elba OB60 Installation Instructions Manual
Elba OB60 Installation Instructions Manual

Elba OB60 Installation Instructions Manual

Built-in ovens

Advertisement

Installation instructions
Built-in ovens
OB60 TOP-OPENING DOOR models
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our
local website listed at the end of this document or contact your local Fisher & Paykel dealer.
1
SAFETY AND WARNINGS
Electrical shock hazard
Always disconnect the appliance from the mains power supply before
carrying out any maintenance or repairs.
Connection to a good earth wiring system is essential and mandatory.
Alterations to the domestic wiring system must only be made by a
qualified electrician.
Failure to follow this advice may result in electrical shock or death.
Fire hazard
Do not use adapters, reducers, or branching devices to connect this appliance to
the mains power supply.
Failure to follow this advice may result in overheating, burning, or fire.
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
WARNING!
WARNING!
WARNING!
Important safety instructions!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
Please make this information available to the person installing the appliance - doing so could reduce
your installation costs.
This appliance must be installed and connected to the mains power supply only by a suitably qualified
person according to these installation instructions and in compliance with any applicable local
building and electricity regulations. Failure to install the appliance correctly could invalidate any
warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
NZ AU

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OB60 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Elba OB60

  • Page 1 Installation instructions Built-in ovens OB60 TOP-OPENING DOOR models NZ AU Important! SAVE THESE INSTRUCTIONS The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed at the end of this document or contact your local Fisher &...
  • Page 2 PRODUCT & CABINETRY DIMENSIONS OB60B MODELS OB60S3 & OB60SC MODELS 16-20 mm 16-20 mm 2.5 mm 2.5 mm Installation diagrams for illustration purposes only Installation diagrams for illustration purposes only Product and cabinetry dimensions Product and cabinetry dimensions (mm) (mm) overall height* of product overall height* of product overall width of product...
  • Page 3: Prior To Installation

    PRIOR TO INSTALLATION ELECTRICAL CONNECTION Important! Before you install the oven, make sure that the benchtop and oven cavity are square and level, and are the required dimensions This oven must be connected to the mains power supply only by a suitably qualified person. the installation will comply with all clearance requirements and applicable standards and regulations This oven must be earthed.
  • Page 4: Final Checklist

    Turn the power to the oven on. On some models, the display should light up and show 0:00. Advise the customer to follow the instructions in their user guide in section ‘First use’ . www.elba.co.nz www.elba.com.au F&P Italy Part No. 1103610-ß1 590093A NZ AU 07.10...
  • Page 5: Safety And Warnings

    Installation instructions Built-in ovens OB60 SIDE-OPENING DOOR models NZ AU Important! SAVE THESE INSTRUCTIONS The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our local website listed at the end of this document or contact your local Fisher &...
  • Page 6 PRODUCT & CABINETRY DIMENSIONS PROUD INSTALLATION FLUSH INSTALLATION 16-20 mm 16-20 mm Important! Doors of adjacent cabinetry may need adjusting to allow the 2.5 mm 5 mm oven door to open properly: a minimum clearance of 5mm is recommended. Installation diagrams for illustration purposes only Installation diagrams for illustration purposes only Product and cabinetry dimensions Product and cabinetry dimensions...
  • Page 7: Special Requirements

    SPECIAL REQUIREMENTS PRIOR TO INSTALLATION Depending on the model, the door is either left- or Before you install the oven, make sure that the benchtop and oven cavity are square and level, and are the required dimensions right-hinged. When determining the location of the the installation will comply with all clearance requirements and applicable standards and regulations oven, ensure there will be enough space for the door a suitable isolating switch providing full disconnection from the mains power supply is incorporated in...
  • Page 8 Turn the power to the oven on. The display should light up and show 0:00. Advise the customer to follow the instructions in their user guide in section ‘First use’ . www.elba.co.nz www.elba.com.au F&P Italy Part No. 1103610-ß1 590093A NZ AU 07.10...

Table of Contents