Cisco 8861 Deployment Manual page 138

Remote Log
Log Profile
Advertise G.722 and iSAC Codecs
Detect Unified CM Connection
Failure
Power Negotiation
Provide Dial Tone from Release
Button
Background Image
Simplified New Call UI
Revert to All Calls
Show Call History for Selected Line
Only
Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
the two parameters are optional. Absence of pfs or base,pfs will be set to the
default value 0 and base will be set to the default value 7.
This parameter specifies where to send the log data by serviceability. If enabled,
the log data will be copied by serviceability to the place specified by Log
Server/IPV6 Log Server. If disabled, the log data will not be copied by
serviceability to the place specified by Log Server/IPV6 Log Server.
Run the pre-defined debug command remotely.
Indicates whether Cisco IP Phones will advertise the G.722 codec to Cisco
Unified CallManager. Codec negotiation involves two steps: first, the phone must
advertise the supported codec(s) to Cisco Unified CallManager (not all endpoints
support the same set of codecs). Second, when Cisco Unified CallManager gets
the list of supported codecs from all phones involved in the call attempt, it
chooses a commonly-supported codec based on various factors, including the
region pair setting. Valid values specify Use System Default (this phone will
defer to the setting specified in the enterprise parameter, Advertise G.722 Codec),
Disabled (this phone will not advertise G.722 to Cisco Unified CallManager) or
Enabled (this phone will advertise G.722 to Cisco Unified CallManager).
This field determines the sensitivity that the phone has for detecting a connection
failure to Cisco Unified Communications Manager (Unified CM), which is the
first step before device failover to a backup Unified CM/SRST occurs. Valid
values specify Normal (detection of a Unified CM connection failure occurs at
the standard system rate) or Delayed (detection of a Unified CM connection
failover occurs approximately four times slower than Normal). For faster
recognition of a Unified CM connection failure, choose Normal. If you prefer
failover to be delayed slightly to give the connection the opportunity to
reestablish, choose Delayed. Note that the precise time difference between
Normal and Delayed connection failure detection depends on many variables that
are constantly changing. This only applies to the wired Ethernet connection.
Default = Normal
You should enable the Power Negotiation feature when connected to a switch that
supports power negotiation. However, if a switch does not support power
negotiation, then you should disable the Power Negotiation feature before you
power up accessories over PoE. When the Power Negotiation feature is disabled,
the phone can power up accessories up to 12.9W
Indicates whether Dial Tone is provided when Release Button is pressed. If the
value is true, then in "Off Hook Dialing/RingingOut/Connected" state, a new Call
Windows will be brought out after Release Button is pressed. If "Revert To All
Calls" feature was enabled, it should be active first before "Dial Tone" feature.
This parameter specifies the default wallpaper file. Only the administrator
disables end user access to phone wallpaper list, could this parameter take effect.
This parameter specifies if use simplified call UI style when the phone is Off-
hook. Those who like the New Call Window can continue to use that at the same
time that those who prefer the Simplified New Call Session can use that method.
When enabled, phone will revert to All Calls after any call is ended if the call is
on a filter other than Primary line, All Calls or Alerting Calls.
When enabled, the phone shows call history for selected line only.
138