Cisco 8861 Deployment Manual page 136

Port
Link Layer Discovery Protocol -
Media Endpoint Discover (LLDP-
MED): Switch Port
Link Layer Discovery Protocol –
(LLDP): PC Port
LLDP Asset ID
LLDP Power Priority
802.1x Authentication
Automatic Port Synchronization
Switch Port Remote Configuration
PC Port Remote Configuration
SSH Access
Incoming Call Toast Timer
Ring Locale
TLS Resumption Timer
FIPS Mode
Record Call Log From Shared Line
Minimum Ring Volume
Peer Firmware Sharing
Load Server
Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
PC port.
Allows administrator to enable or disable Link Layer Discovery Protocol (LLDP-
MED) on the switch port.
Allows administrator to enable or disable Link Layer Discovery Protocol (LLDP)
on the PC port.
Allows administrator to set Asset ID for Link Layer Discovery Protocol.
Allows administrator to set Power Priority for Link Layer Discovery Protocol.
Specifies the 802.1x authentication feature status
Enables the phone to synchronize the PC and SW ports to the same speed and to
duplex. Only ports configured for auto negotiate change speeds.
Allows remote configuration of the speed and duplex for the switch port of the
phone, which overrides any manual configuration at the phone. Be aware that
configuring this port may cause the phone to lose network connectivity.
Allows remote configuration of the speed and duplex for the PC port of the
phone, which overrides any manual configuration at the phone.
This parameter indicates whether the phone will accept ssh connections.
Disabling the ssh server functionality of the phone will block access to the phone.
This parameter specifies the maximum time in seconds that the toast displays a
new incoming call notification.
IP Phone has distinctive ring for On-net/Off-net or line based, but its ring cadence
is fixed, and it is based on US standard only. Ring cadence in US standard is
opposite to Japan standard. To support Japan ring cadence, the ring cadence
should be configurable according to Ring Locale.
The current TLS session to support TLS session resumption is HTTPs client. The
HTTPs client sessions support configurable session resumption timer. The timer
specifies the maximum session resumption time allowed. If the value is set to 0,
TLS session resumption will be disabled.
This parameter specifies if the fips mode is enabled or disabled.
This field indicates whether or not to record call log from shared line.
This parameter controls the minimum ring volume on an IP phone. This value is
set by the administrator, and can not be changed by an end user. The end user can
increase the ring volume, but may not decrease the ring volume below the level
defined. The minimum ring volume range is from 0 to 15, with 0 (silent) being
the default value.
Enables or disables Peer to Peer image distribution in order to allow a single
phone in a subnet to retrieve an image firmware file then distribute it to its peers
– thus reducing TFTP bandwidth and providing for a faster firmware upgrade
time.
Indicates that the phone will use an alternative server to obtain firmware loads
and upgrades, rather than the defined TFTP server. This option enables you to
indicate a local server to be used for firmware upgrades, which can assist in
136