Table of Contents
Advertisement
list of compatible DIMM.
·
The memory module may not be installed properly. Go back to Chapter 4 to review the details of this operation.
·
The memory module may be defective.
The O/S issues an insufficient memory error message during operation -
·
This is often a software or Windows-related problem. A program is draining the memory resources.
·
Close the application programs you're not using and restart the system.
·
You need to install additional memory module. For instructions, go to Chapter 4 Upgrading Your Computer.
Modem Problems
The built-in modem does not respond -
·
Make sure the modem driver is loaded properly.
·
Go to [Start > Settings > Control Panel > Phone and Modem Options] and go to Modems tab. Make sure
SmartLink 56K Voice Modem or Uniwill V.92 Modem is listed. Otherwise, click the Add button to add the modem
drive, which is located in the factory CD-ROM (or floppy diskette).
·
Go to [Start > Settings > Control Panel > System] and click Device Manager button in the Hardware page to
check for possible resource or driver conflict. See Windows on-line help or manual for how to handle such
problems.
·
Make sure the phone line, which the computer is connected to, is working.
Connection difficulties -
·
Be sure to disable Call Waiting on the phone line.
·
Be sure to have the correct country setting where your computer is used. [Start > Settings > Control Panel >
Modem Settings > Configuration] In the Country/Area pull-down menu, select the appropriate country setting.
·
Excessive line noise might cause the connection to be dropped. To check this, put the regular phone handset on
the line and placing a phone call. If you do hear abnormal noise, try to make the modem connection with a
different line or contact your local telephony company for service.
·
Make sure the cable connection is firm.
·
Try a different receiver number and see if the problem persists.
Network Adapter / Ethernet Problems
The Ethernet adapter does not work -
·
Go to [Start > Settings > Control Panel > System > Hardware > Device Manager]. Double-click on Network
Adapters and check if Realtek RTL8510EX Family Fast Ethernet NIC appears as one of the adapters. If it does not
exist, Windows has not detected the Realtek RTL8510EX Family Fast Ethernet NIC or the device driver has not
been installed properly. If there is a yellow mark or red-cross on the network adapter, it may be a device or
resource conflict. Replace or update the device driver from the factory CD-ROM disk or consult Windows manual
on how to solve the resource conflict problem.
·
Make sure the physical connections on both ends of the cable are good.
·
The hub or concentrator may not be working properly. Check to see if other workstations connected to the
same hub or concentrator is working.
The Ethernet adapter does not appear to operate in the 100/1000Mbps transmission mode -
·
Make sure the hub you are using supports 100/1000Mbps operation.
PRESTIGIO AVANTI 1592W
35
Advertisement
Table of Contents
