Disposal Of Packaging Materials; Charging The Power Bank - Silvercrest SPB 6000 A1 Operating Instructions Manual

Disposal of packaging materials

Returning the packaging into the material cycle conserves
raw materials and reduces the amount of waste generated.
Dispose of packaging materials that are no longer needed in
accordance with applicable local regulations.

Charging the Power Bank

Before using the Power Bank, the integrated battery must be
fully charged. The required charging time for the Power Bank is
dependent of the charging source and its output (max. 5 V/2.1 A).
CAUTION!
► Due to the high battery capacity and bearing in mind
the charging time, we recommend charging the power
bank using a USB mains adaptor (not supplied).
► Use only a USB mains adapter with an output voltage
of 5 V and an output current of at least 2.1 A to charge
the power bank.
Option A
♦ Connect the USB plug
supply (not supplied).
A rough estimate of the current charge level is shown during
charging by means of the charge level LEDs
LED display
One LED is flashing
One LED is on, the second LED is flashing
Two LEDs are on, the third LED is flashing
Three LEDs are on, the fourth LED is flashing
All LEDs are on
│ GB │ MT
■ 34
The packaging protects the device from damage
during transport. The packaging materials have
been selected for their environmental friendliness
and ease of disposal, and are therefore recyclable.
of the power bank to a USB power
:
Charge
level
< 25%
25–49%
50–74%
75–99%
100%
SPB 6000 A1