Table of Contents
Advertisement
5. FACTORS INFLUENCING VAPORIZ ATION
The amount of aromas and fragranc-
es released into the Valve Balloon can
be influenced by the following factors:
1. Quality: The amount of aromas
or fragrances contained in the
respective plant material that can
be vaporized.
2. Quantity: The amount of vaporiza-
tion material in the Filling Chamber.
3. Surface: The finer the plant is
ground, the greater the surface
and the more aromas and fra-
grances can be released during
the vaporization cycle.
4. Temperature: The higher the
temperatures, the more aromas
and fragrances will be released at
once.
Please note: Increasing the tempera-
ture should be the last resort, because
plant material tastes more toasted
when using higher temperature.
Since the plant ingredients are re-
leased in a gentle manner, the vapor-
ization cycle may be repeated with the
same contents in the Filling Chamber.
Depending on the four factors de-
scribed above, the load of the Filling
Chamber may be reused multiple
times until the aromas and fragrances
are released completely. It is advised
to take out the content of the Filling
Chamber and grind it once again to
increase the surface of the original
material. An increased temperature
would activate more vapor as well, but
has a negative effect on the taste. If
no more vapors are visible at the high-
est temperature, then the vaporization
material is completely exhausted and
must be replaced with new material.
However, for the best aroma results it
is advisable to replace the vaporiza-
tion material before this point.
It is important to watch the vapor den-
sity in the Valve Balloon. A fine, white
vapor feels very comfortable when
inhaled. As the vapor gets denser the
taste can get too strong. A very high
intensity (density) of the vapor can
lead to irritation of the respiratory pas-
sages from the concentration of the
aromas and fragrances. In this case,
the temperature should be lowerd,
so that the intensity of the vapors is
reduced.
ok
Watch vapor density
12
5. FACTORS INFLUENCING VAPORIZ ATION
It is not necessary to fill the Valve Bal-
loon completely. It is often sufficient to
fill only half or even less than half of
the Valve Balloon in order to achieve
the desired results.
The Valve Balloon is not suitable for
storing vapors over a long period be-
cause the vapors condense on the
Valve Balloon Jacket over time (a few
hours). Only fill the amount you want
to inhale within 10 minutes.
Breathing Techniques
The device is not to be used, if
the user has respiratory tract
or lung conditions. Depending
on the density, the vapor could irritate
respiratory tracts or lungs, which can
lead to coughing.
Inhale only half the amount of air
you can normally manage. Hold your
breath for a few seconds and then
exhale slowly. It is advisable to delib-
erately concentrate on your breathing
process.
13
Hide quick links:
Advertisement
Table of Contents
