Programming Volume Lock - Universal Electronics Potenza ST Manual

PROGRAMMING VOLUME LOCK

Volume Lock allows you to control the volume through the device identified as having your
primary speakers(s), regardless of which mode you are using. On the Potenza ST Remote by
default the global volume Lock is set to TV, so you can control TV volume while in the TV, DVD,
AUX, or STB mode. The volume lock feature is programmable. Perform individual Volume
Unlock on a selected device to set its volume control for independent operation.
NOTE: The audio mode's (AUD) volume controls are active regardless of Volume Lock settings. However, if you
lock the volume controls to the AUD mode, you will control the audio device's volume in all other modes (i.e. TV,
DVD, AUX, or STB). This can be an advantage if, for example, you always listen to home entertainment devices
through your device's speakers.
Programming Global Volume Lock
The user can globally lock the volume controls to one source mode (Device Key):
1. Press and hold SETUP key until the device key blinks twice.
2. Enter 9 9 3 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly.
3. Press VOL + key and release.
4. Press Device Key you want to be the master audio source (TV, AUD).
Programming Global Volume Unlock
The user can reset the volume controls to that one source mode:
1. Press and hold SETUP until the device key blinks twice.
2. Enter 9 9 3 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly.
3. Press VOL - key and release.
Programming Single-Device Volume lock
1. Press the desired Device Key (TV, AUD) to lock the volume to and release.
2. Press and hold SETUP key until it blinks twice.
3. Enter 9 9 3 and release.
Note: The LED will blink 2 times after any three-digit programming sequence is entered correctly.
4. Press the Device Key (STB, TV, AUD) that you want to have the volume control locked
to the device selected in step 1.
5. Press SETUP and release.
Note: The last selected device LED will blink 2 times if programming sequence is entered correctly.
Note: After you select a device that has volume unlocked (i.e. STB), pressing VOL+, VOL-, or Mute, will control only that
device's volume.