Whirlpool W10562346B Use And Care Manual page 12

TROUBLESHOOTING
First try the solutions suggested here or visit our website at www.whirlpool.com/product_help -
In Canada www.whirlpool.ca for assistance and to possibly avoid a service call.
If you experience Possible Causes Solution
Cycle time too short Sensor Cycle ending early.
Lint on load
Stains on load or drum
Lint screen clogged.
Dryer fabric softener not properly
used.
Loads are wrinkled Load not removed from dryer at the
end of the cycle.
Dryer tightly packed.
Odors You have recently been painting,
staining, or varnishing in the area
where your dryer is located.
The load may not be contacting the sensor strips. Level the
dryer.
Use Timed Dry for very small loads. Change the dryness level
setting on Sensor Cycles.
Increasing or decreasing the dryness level will change the
amount of drying time in a cycle. If loads are consistently ending
too early, see also Changing the Sensor Cycle Default Settings.
Lint screen should be cleaned before each load.
Add dryer fabric softener sheets at the beginning of the cycle.
Fabric softener sheets added to a partially dried load can stain
your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).
These will not transfer to other clothing.
Select Wrinkle Shield feature to tumble the load without heat to
avoid wrinkling.
Dry smaller loads that can tumble freely reduce wrinkles from
forming.
If so, ventilate the area. When the odors or fumes are gone from
the area, rewash and dry the clothing.
The electric dryer is being used for The new electric heating element may have an odor. The odor
the first time. will be gone after the first cycle.
Load is too hot Laundry items removed from the Allow the Cool Down cycle to finish before removing laundry
dryer before the end of the cycle, from dryer. All cycles are cooled slowly to reduced wrinkling and
make it easier to handle. Items removed before Cool Down may
feel very warm.
A high temperature cycle was used Select a lower temperature, and use an sensor drying cycle.
or the Temp was set on high. These cycles sense the temperature or the moisture level in the
load and shut off when the load reaches the selected dryness.
This reduces overdrying.
12