Calix T072G Operation And Maintenance Manual page 31

The following table describes the parameters.
Parameter Description
Parameter
IP Protocol Version
Destination IP
Address
Destination Netmask
Gateway
IPv4 Interface
Add Button
Delete Button
Save Button
Refresh Button
After the configurations are done, click Save button to save it. Reboot the device to make the
modification to take effects. Refer to Reboot Device (on page 52) or press reset button to
reboot the system.
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
Select the IP protocol version. Currently only IPv4 is available.
Input the destination IP address.
Input the destination subnet Mask.
Input the outgoing gateway address.
Select the WAN ports that this route uses.
Note :"br0" means the WAN port of ONU itself.
Click this button, to add a new static routing rule for above
parameters.
Delete the MAC to IP binding rule in the local gateway tables.
Save the configuration.
Clear the configuration without being saved.
© Calix. All Rights Reserved.
Description
31