Debris Shield Assembly - Shindaiwa T300 Owner's/Operator's Manual

5-6 Debris Shield Assembly

WARNING!
NEVER operate this machine
without the cutting attachment shield.
Operating without the cutting attach-
ment shield may result in serious injury.
(A) Cutting Attachment Shield
(1) Insert the cutting attachment
shield between the outer tube and
the lower clamp. Loosen the nut and
bolt which are tightening the lower
clamp if the cutting attachment
shield does not fit with the lower
clamp.
NOTE:
It may be necessary to loosen the lower
clamp bolt so that the shield will fit
between the tube and clamp.
(2) Fit the two spacers and the upper
clamp over the outer pipe and
tighten with four bolts.
NOTE:
Tighten four bolts a crisscross fashion.
(3) Tighten the lower clamp bolt and
nut securely.
WARNING!
Carefully inspect the debris
shield assembly to make sure it is tight-
ened securely and does not wobble.
(B) Shield Extension (when trimmer
head is in use)
(1) Attach the shield extension to the
cutting attachment shield.
NOTE:
Make sure the shield extension is
completely hooked at the hook re-
ceiver.
9