Assembly Of The Handle; Throttle Cable Adjustment - Shindaiwa T300 Owner's/Operator's Manual

5-4 Assembly of the Handle

(A) T300
WARNING!
NEVER operate this machine
without the front handle. Operating with-
out the front handle may result in seri-
ous injury.
NOTE:
Tighten four bolts diagonally to
properly secure the handle.
NOTE:
Adjust the handle at the best posi-
tion for operator comfort.
(1) Put four square nuts in the
recesses on the underside of the
barrier.
(2) Fit the handle and barrier over
the outer pipe and tighten four bolts.
8
(B) C300
(1) Loosen the two bolts of the lower
cap and remove the lower cap.
(2) Position the handle bracket
against the handle label located on
the outer tube.
(3) Attach the lower cap with the two
bolts and tighten the bolts. Make
sure the front handle is in position
per the illustration.
(4) Secure the cable to the outer pipe
with the two bands as the illustration
shows. The two bands are in the tool
bag.
HANDLEBAR
HANDLE BRACKET
HANDLE LABEL
BOLT
LOWER CAP
BAND

5-5 Throttle Cable Adjustment

(1) Pull the throttle trigger gently,
and check for free-play of
approximately 5mm.
(2) If free-play is out of specifications:
(a) Slide the cable cap toward the
muffler side until the adjusting
nut and the lock nut appear.
(b) Loosen the lock nut slightly.
(c) Turn the adjusting nut so that
free-play is about 5mm.
(d) Then, tighten the lock nut.
(e) Slide the cable cap back.
THROTTLE GRIP
CABLE CAP
LOCK NUT
ADJUSTING NUT