Debris Shield Assembly - Shindaiwa T300 Owner's/Operator's Manual

Debris Shield Assembly

WARNING!
NEVER operate this ma-
chine without the cutting
attachment shield. Operating without
the cutting attachment shield may
result in serious injury.
Cutting Attachment Shield
1. Insert the cutting attachment shield
between the outer tube and the lower
clamp. Loosen the nut and bolt which
are tightening the lower clamp if the
cutting attachment shield does not fit
with the lower clamp.
NOTE:
It may be necessary to loosen the lower
clamp bolt so that the shield will fit between
the tube and clamp.
2. Fit the two spacers and the upper clamp
over the outer pipe and tighten with
four bolts.
NOTE:
Tighten four bolts a crisscross fashion.
3. Tighten the lower clamp bolt and nut
securely.
WARNING!
Carefully inspect the debris
shield assembly to make
sure it is tightened securely and does
not wobble.
BOLT
UPPER OUTER TUBE
CLAMP
SPACER
BOLT
SPACER
LOWER CLAMP
NUT
Shield Extension (when trimmer
head is in use)
1. Attach the shield extension to the
cutting attachment shield.
Make sure the shield extension is completely
hooked at the hook receiver.
CUTTING ATTACHMENT SHIELD
SHIELD EXTENTION
CUTTING
ATTACHMENT
SHIELD
NOTE:
HOOK
RECEIVER
HOOK
9