Advertisement
Insert Preparation and Placement
Place the extending hopper into its highest position (see the manual for details). This increases the pellet
capacity of the heater.
Install the surround panels onto the insert and slide it into place. The surround panels must maintain a
3/8" gap from the enclosure opening (the stand-offs on the surround panels provide the 3/8" spacing).
After the insert is in place, attach the vent starter section to the insert (it is attached with a latch – make
sure the gasket is correctly positioned).
The leveling bolts may be used to level the insert.
We recommend the use of the Insert Wiring Kit when installing this kit (SKU 97200315). This kit allows
for the power cord to be hard-wired behind the walls, eliminating the need for a visible power cord.
Rear Vent Shield (used only on inserts
venting directly to the rear - note how it is
slid back until it contacts the wall thimble)
Minimum
House Shield
(prevents soot discoloration)
HIGHLY RECOMMENDED
Outside Air
Connection
(recommended)
Page 8 of 8
ZC Kit – Large Pellet Insert
12"
Wall Thimble (note 3" clearance between
vent and combustibles)
(99200149)
Vent Clearances (make sure
all vent maintains 3" clearance
to any combustible)
Vent Latch (used to connect and
disconnect the vent )
10/9/06
Enclosure Height
(measure from top of
floor protection)
Floor Protection
© Travis Industries, Inc.
Advertisement
