Geeetech GiantArm D200 User Manual page 20

3.3.2 Leveling
Choose the [Leveling] button to enter the leveling interface. This interface is used for leveling of build
platform, as shown in the picture below.
Click to enter the interface, the printer will be homed first and Z axis will rise to 0mm to wait for leveling
Move the nozzle to the five points in turn as shown in the picture to level the platform. During this process,
you can use the z+/z- to fine-tune the position of the nozzle. Click [OK] to save the height of the platform.
a. Choose Z↑: The hotbed moves upward by 0.5mm and set the coordinate of Z axis at 0mm. The value in
the [Z:] is the updated height of the platform.
↓
b. Choose Z : The platform moves downward by 0.5mm and set the coordinate of Z axis at 0mm. The
value in the [Z:] is the updated printing height.
c. Click [OK] to save the updated height of the platform.
d. Choose [1]: The platform moves downward by 10mm and the nozzle moves to the [1] point. Then the
platform moves upward to 0mm (the original coordinate of Z axis).
By that analogy, you can level the platform at the other 4 points.
e. Choose
homed.
f. : Displaying the real-time height of the platform.
(Note: You can finish the leveling job of the 5 points out of
to return to the main interface of [settings]. At the same time, the motors will be
sequence)
20