Turning On The Power - Eizo DuraVision FDF4627W-IP Manual

Turning On the Power

1.
Turn on the main power switch on the back of the monitor.
The main power switch is turned on when factory default settings are configured.
2.
Press on the front of the monitor or
The power indicator lights up blue and the live image screen is displayed. For details on the live
image screen, refer to the Instruction Manual.
Network camera image display area
Attention
• By default, it takes approximately one minute for the live image screen to be displayed after the power is
turned on (A rotating bar indicating startup is displayed). Do not turn off the monitor during startup.
• Default settings are displayed in English during configuration. For how to set the language, refer to "Configuring
the Language" (page 17).
• When the monitor is started up for the first time, a menu for operating the monitor and network cameras is
displayed.
• When no network camera is registered, a "Not Registered" message is displayed at the network camera
image display area.
Note
• The time required to display the live image screen can be reduced (Quick Start) by changing the power-off
status. For details, refer to the Installation Manual.
• Press ' on the front of the monitor or
• When using a USB mouse, connect the mouse to the USB downstream port at the back of the monitor.
on the remote control.
Message display area
on the remote control to turn off the power.
Menu
13