Specifications - Makita GA7030 Instruction Manual

ENGLISH
1-1. Shaft lock
2-1. Motor housing
2-2. Lock button
2-3. Handle
3-1. Switch trigger
3-2. Lock lever
5-1. Wheel guard
5-2. Screw
5-3. Bearing box
6-1. Bearing box
6-2. Wheel guard
6-3. Nut

SPECIFICATIONS

Model
Depressed center wheel diameter
Spindle thread
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for grinding, sanding and cutting of
metal and stone materials without the use of water.
Explanation of general view
6-4. Lever
7-1. Nut
8-1. Lock nut
8-2. Depressed center wheel
8-3. Super flange
8-4. Inner flange
9-1. Lock nut
9-2. Depressed center wheel
9-3. Inner flange
10-1. Lock nut wrench
10-2. Shaft lock
11-1. Lock nut
GA7030/GA7030F
GA7030S/GA7030SF
-1
)
5.1 kg
equipment
environmentally
GA7040S/GA7040SF
180 mm
M14
8,500
511 mm
5.5 kg
END202-2
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under
unfavorable mains conditions can have adverse effects
to the operation of other equipment. With a mains
impedance equal or less than 0.23 Ohms it can be
and its
presumed that there will be no negative effects. The
mains socket used for this device must be protected with
a fuse or protective circuit breaker having slow tripping
characteristics.
For Model
compatible
GA7030,GA7030F,GA7030S,GA7030SF,GA9040S,GA
9040
ENE048-1
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 89 dB (A)
sound power level: 102 dB (A)
4
11-2. Outer flange 78
11-3. Cut-off wheel
11-4. Inner flange 78
11-5. Dust collecting wheel guard
13-1. Exhaust vent
13-2. Inhalation vent
14-1. Commutator
14-2. Insulating tip
14-3. Carbon brush
15-1. Brush holder cap
15-2. Screwdriver
GA9030/GA9030F
GA9030S/GA9030SF
230 mm
M14
6,600
511 mm
5.1 kg
/II
GA9040S/GA9040SF
5.5 kg
ENF002-1
ENF100-1
ENG021-1