Connecting The Water Supply (Ph27A Only) - Defensor PH27 Operating Instructions Manual

After locating the unit:
• Lock the wheels of the carriage
• Remove rear air inlet lattice and take it out of the unit as shown below (at the point of the delivery
the mains cable is placed behind the air inlet lattice). Then, remount air inlet lattice.
4.4

Connecting the water supply (PH27A only)

The water supply has to be connected to the unit by a qualified specialist according to the illustration
below. The installation data has to be maintained.
Important! The local regulations regarding the connection of units to drinking water systems must
be observed.
Plug-in coupling ø 10 mm
1.
4.
3.
2.
Water pipe ø 10/ mm
with R 3/" connector
Filter valve (accessory "Z21")
Drinking water without additives:
– Admissible water pressure: 0.....0 bar
ø 10/ mm
– Admissible water temperature: ...0 °C
1
unlock
lock