Table of Contents
Advertisement
42 Check that there's water in the reservoir.
43 Set the temperature control to max, set the steam control to S.
44 Hold the iron close to (but not touching) the fabric.
45 Press the ~ button (you're using the "shot of steam" function vertically).
46 You may have to press it 2 or 3 times to pump water through the system.
47 Leave 4 seconds between shots, to let the temperature build up.
C AFTER USE
48 Set the temperature control to •, set the steam control to S.
49 Unplug the iron.
50 Open the cover.
51 Hold the iron over a sink, turn it upside down, and drain the water from the reservoir.
52 Sit the iron on its heel.
53 Leave it to cool down completely.
54 When it's cold, wipe off any moisture, and close the water inlet cover.
55 Clean the outside surfaces of the appliance with a damp cloth.
56 Remove spots from the soleplate with a little vinegar.
57 Store the iron on its heel, to avoid corrosion and damage to the soleplate.
C SELF CLEAN
58 To prevent scale building up, use the self clean function at least monthly in normal
water areas, more often in hard water areas.
, Products returned under guarantee with faults due to scale will be subject to a
repair charge.
59 You'll need a basin or a large bowl to catch the water coming out of the soleplate.
60 Fill the reservoir to the max mark.
61 Set the temperature control to max. Set the steam control to S.
62 Sit the iron on its heel.
63 Put the plug into the power socket.
64 Wait till the thermostat light goes out.
65 Hold the iron over the basin or bowl, with the soleplate down.
66 Move the steam control to C , and hold it there.
67 Gently move the iron to and fro.
68 Water and steam will wash scale and dust through the soleplate.
69 Carry on till the reservoir is empty.
70 Set the steam control to S.
, Jump to point 48.
e ANTI-SCALE
70 The anti-scale agent incorporated in the iron helps prevent the build-up of scale.
71 Don't use a descaling solution, or you'll destroy the anti-scale agent.
5
Advertisement
Table of Contents
