Table 3-17. Programming Cables - Motorola ASTRO Digital XTL 5000 Detailed Service Manual

Theory of Operation: Controller Section
For a list of all available programming cables, refer to the table below.
Motorola
Part Number
HKN6155 Programming Flash Cable
RVN4185 Customer Programming Software and
Tuner Software
HKN6182 High Power GCAI Cable Adapter for
Keyloader
HKN6183 High Power GCAI to RS232
Programming Cable
HKN6184 High Power GCAI to USB Programming
Cable
HKN6122 4-wire data cable, J6 remote TIB
HKN6160 Cable Kit 6' Dash Mount Data (RS232)
If you choose to reflash the radio (reflash the IC), DO NOT interrupt the
!
process; otherwise, you might corrupt the FLASH IC and need advanced
technical support to revive your radio.
C a u t i o n
NOTE: In remote-mount configurations, the control head 10-pin microphone port is disabled for any
kind of programming.
NOTE: FLASH IC replacement is not supported as a field repair option. If the FLASH IC is removed,
the radio cannot be reflashed by a customer or radio depot. This is because the FLASH IC
must be hard-boot loaded at the factory to allow the programming of a unique file.
6881096C74-B

Table 3-17. Programming Cables

Description Application
Used with Tuner software, Customer Programming
Software (CPS), and FLASHport
Programming and radio alignment software on CD
Used for keyloading XTL 5000 High Power
Used for programming XTL 5000 High Power
Used for programming XTL 5000 High Power
Used for programming XTL 5000
Used for programming XTL 5000 Mid Power
3-77
May 25, 2005