Setting Backlight - Motorola MTP8500Ex User Manual

4.10.7.4

Setting Backlight

When and where to use: To save the battery power.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → Backlight.
3 Select one of the following:
• Auto — backlight is triggered by turning on the radio, by pressing any key on the device or
on the accessory that is connected to it. Also charging or getting signal from the services like:
Call-Out message, RUA request, DGNA and TX timeout during priority call are going to turn
on the backlight.
• Semi Auto — backlight is turned on when you are switching on the radio, pressing assigned
button to the backlight feature, or charging.
• Disabled — backlight is disabled and the display is always dimmed.
4.10.7.5
Setting Brightness
When and where to use: To set the luminance of the display and the keypad in an environment with
low visibility.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → Brightness.
3 Select one of the following:
• Level — allows you to manually set the brightness level using the Left or Right Navigation
key.
• Automatic — enables or disables the automatic brightness mode, in which the radio uses a
photo sensor to automatically adjusts brightness to the ambient light. However, it is still
possible to adjust brightness using the Left or Right Navigation key in the Level menu.
4.10.7.6
Setting LCD Off
When and where to use: This feature sets the time so the display automatically turns off after a
specific amount of time.
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup → Display → LCD Off.
3 Select one of the following:
• Disabled — your radio display never goes off.
• 30 seconds — turns off the radio display after 30 seconds.
• 1 minute — turns off the radio display after 1 minute.
• 2 minutes — turns off the radio display after 2 minutes.
Send Feedback
MN002033A01–AC (en-US)
Chapter 4: Main Menu
107