Installing The Ap - Motorola PMP 320 User Manual

2.3 INSTALLING THE AP
General communications equipment, infrastructure, and facilities site design should be
performed
in line with Motorola's "Standards and Guidelines for Communications Sites" (al
k nown as the
R56 manual) available from
http://ww w.motorola‐wls.com/Dynamic/Course_Description.asp?number=ANT001‐
CD&CourseKe
y=125
T hese procedures are specific to the case of as AP purchased as a kit consisting of a
connectorized antenna and a connectorized radio.
A short coaxial cable from the radio terminates in a male N connector. The antenna has
a chassis‐mounted female N connector. The antenna includes tower mount brackets
with adjustable down‐tilt.
Installing an AP typically consists of four phases:
1 . Configure the AP at an operator's facility or at the installation site using the
in formation and settings defined in the Planning and Configuring sections of this user
guide.
2. Assemble the AP (radio, ante
Procedure 2. A CMM4 is typically installed at the same time, if not previously
installed.
3. Cable the AP to the CMM4 and ground it to Protective Earth – PE using Procedure
4. This phase can also include cabling to backhauls, or running terrestrial feeds.
5. Confirm operation, using SMs in the field.
Local practices and choices of installation options will dictate the actual processes. For
example,
variations on these generalized procedures can be used to install on a building or install
multiple
APs on a pipe mount before hoisting up a tower for final attachment.
nna, and brackets) and physically install it using
so
15