Table of Contents
Advertisement
Chapter 10
Done!
•
Destination IP:
The destination IP address that you want to
assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of the router. In the example,
the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
•
Subnet Mask:
Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
•
Gateway:
The IP address of the gateway device to which the
data packets will be sent. This IP address must be on the same
subnet with the router's IP which sends out the data. In the
example, the data packets will be sent to the LAN port of
Router 2 and then to the Server, so the default gateway should
be 192.168.1.2.
•
Interface:
Determined by the port (WAN/LAN) that sends
out the data packets. In the example, the data is sent to the
gateway through the LAN port, so LAN should be selected.
5 Select the check box to enable this entry.
6 Click
OK
to save the settings.
Open a web browser on your PC. Enter the company server's IP
address to visit the company network.
52
Advertisement
Table of Contents
