Dodge Charger SRT 3922016 Owner's Manual page 425

NOTE: Pushing the SRT button on the center stack or
pressing the "Apps" button on the touchscreen are two
other options to access launch control features. Please
refer to "Uconnect Settings" in "Understanding Your
Instrument Panel" for further information.
2. Push the "Launch RPM Set-Up" button on the touch-
screen. This screen will allow you to adjust your
launch RPM's for optimum launch/traction.
3. Push the "Activate Launch Mode" button on the
touchscreen.
4. Make sure the vehicle is not moving.
5. Make sure the steering wheel is pointing straight.
6. Hold the brake and make sure the vehicle is in "Drive"
or "AutoStick" position.
7. While holding the brake, rapidly apply the accelerator
pedal to wide open throttle. The engine speed will
hold at the RPM that was set in the "Launch RPM
Set-up" screen.
NOTE: Messages will appear in the Driver Information
Display (DID) to inform the driver if one or more of the
above conditions have not been met.
8. When conditions 4 through 7 have been met, the
Driver Information Display (DID) will read "Launch
Ready Release Brake".
9. Keep the vehicle pointed straight.
Launch control will be active until the vehicle reaches
62 mph (100 km/h), at which point the ESC system will
return to its current ESC mode.
I n f o r ma t i o n P r o v i d e d b y :
STARTING AND OPERATING 423
5