Dodge Charger SRT 3922016 Owner's Manual page 299

• Pushing and holding the OK button will clear the
current and last run values.
Current G-Force
When selected, this screen displays the current G-Force
(lateral and longitudinal) that displays the directions of
the forces.
Peak G-Force
When selected, this screen displays all four G-Force
values (two lateral and two longitudinal).
• When a force greater than zero is measured, the
display will update the value as it climbs. As the
G-Force falls, the peak forces will continue to display.
• Push and hold the OK button to clear the peak force
values.
UNDERSTANDING YOUR INSTRUMENT PANEL 297
Lap Timer
When selected, the Lap Timer page will show the timer
always at 0:00.00 with the previous Best and Last time
data (unless the driver has cleared it via hold to Reset).
• Pushing OK will start "current" timer from 0:00.0.
• When OK is pushed, the times are updated accord-
ingly.
• As soon as the driver exits the Lap Timer pages, the
"current" timer will stop and the time will be reset to
0:00.00.
• If the driver stays on the Lap Timer pages, the "cur-
rent" timer will reset to 0:00.0 when ignition is placed
in the off position, or ignition placed in the ON
position (or will roll over at 59:59.99 if ever possible).
• Each time the driver pushes OK for a Lap that current
time populates, the Last time and also populates the
I n f o r ma t i o n P r o v i d e d b y :
4